The SuperPole™ Basic with SuperBar™

The SuperBar™ rail pivots to move with you in safe, small steps providing "moving support".

Sometimes you need something to pull on or push on to provide that extra support for getting out of bed, off the toilet or out of the tub. You'll notice a greater feeling of stability with the SuperPole™ Basic with SuperBar™.

A gentle lift unlocks the bar to allow it to move. The SuperPole™ acts as the center anchor allowing the SuperBar™ to pivot 360º. The SuperBar™ can lock every 45º to assist with standing, sitting or transferring.

Disabled living can mean difficult transfers for you or a caregiver. The Superpole series makes these transfers so much easier, making every room more handicapped accessible. The Superpole can be used instead of or in addition to toilet grab bars or other bathroom grab bars. It is an excellent alternative to the bathtub grab bar. It supports you while you step over the edge of the tub. (Must be installed outside the bath or shower, as it cannot get wet. For in the shower, see the Stainless SuperPole)

This height adjustable pole is held "rock solid" by simple jackscrew expansion (tension-style mount) between the floor and ceiling. The jackscrew is conveniently located at the bottom of the pole and gives a generous range of fit, 93 - 99 inches high. For an additional 21" of height see the Uni-Fit Height Extender (See the "Accessories Tab" for details.) Custom heights are also available by special order.

The SuperPole with SuperBar™ is easy to install and easy to relocate - no drilling, no screws. And it has rubber pads that ensure no marring of the ceiling or the floor.

Installation Rating

Assembly is difficult, special skills may be required.

• The SuperPole™ with SuperBar™ should only be installed between floors and ceilings of solid construction or injury may result.
• The SuperPole™ should not be installed on loose floor coverings, in rooms with radiant ceiling heating, in mobile homes, or in suspended or angled ceilings without special mounting accessories.

Angled Ceiling Anchor

Do you need to use your SuperPole in a room with a slanted ceiling? The Angled Ceiling Anchor replaces the standard ceiling plate, allowing you to secure the Basic Superpole to slanted ceilings with a slope of 45º or 90º. (This item can be used in conjunction with the Uni-fit Height Extender.)

Uni-Fit Height Extender

The Uni-Fit extends the height of a standard SuperPole to fit any ceiling height from 100 - 120 inches. The Uni-Fit is a separate piece that slides over the top end of the SuperPole and has pre-drilled holes to adjust the height properly.